Publicité
Front Differential Removal
3.
3x15mm BCS
5.
3x15mm BCS
4.
3x15mm BCS
5. Remove the two 3x15mm button head screws from the
differential cover and set the differential cover aside.
6. Remove the two screw pins that fasten the driveshafts to the
differential output.
7. Installation is the reverse of above.
Rear differential:
1. Remove the two 3x25mm countersunk screws from the
underside of the chassis.
2. Remove the two 3x15mm button head screws from the
differential case, set the splitter/rear body mount assembly aside.
3. Remove the 3x15mm button head screw from the rear tie bar
and set aside.
4. Remove the two 3x15mm button head screws from the
differential cover and set the differential cover aside.
Rear Differential Removal
4.
3x15mm BCS
2.
3x15mm BCS
5.
3.
3x15mm BCS
5. Remove the two screw pins that fasten the driveshafts to the
differential output.
6. Installation is the reverse of above.
Refilling the differential:
1. Remove the four 2.5x12mm screws from the differential case
6.
and carefully pull the differential
case halves apart. Work over a
towel to collect any fluid that drips
from the differential.
1. 3x10mm
1.
4x15mm CCS
2. Drain the fluid from the differential.
CCS
2.
4x30mm CCS
You may wish to remove the spider
gears from the differential to make
this easier.
3. Place the spider gears back into the
differential case, if you removed
them. Fill the differential case with
fluid until it the spider gears are
submerged half way.
4. Rejoin the differential case halves, using care to align the screw
holes. Be sure the rubber gasket is in place, or the differential
may leak.
5. Install the 2.5x12mm screws and tighten securely.
1-888-TRAXXAS
1.
3x25mm CCS
www.modellmarkt24.ch
ADVANCED TUNING ADJUSTMENTS
If you have questions or need technical assistance, call Traxxas at
(1-888-872-9927) (U.S. residents only)
XO-1
27
•
Publicité
