Publicité
TRAXXAS STABILITY MANAGEMENT (TSM)
Traxxas Stability Management or
TSM allows you to experience all
the speed and acceleration that
was engineered into your Traxxas
model by helping you to maintain
control of the vehicle in low-
traction situations. TSM helps provide straight ahead full-throttle
acceleration on slippery surfaces, without fishtailing, spinouts, or
loss of control. TSM also dramatically improves braking control. High
speed cornering and control is also made possible as TSM makes
corrections for you, without intruding on your fun, or creating
unexpected side effects.
The Multi-Function knob on
the TQi transmitter has been
programmed to control TSM.
The recommended (default)
setting for TSM is to rotate the
knob to the 12:00 position (the
zero mark on the dial).
Turn the knob clockwise to
increase assistance; turn the knob
counterclockwise to decrease
Decrease
assistance. Turn the
assistance
knob counterclockwise to its
stop to turn TSM completely off.
Note: TSM is deactivated
TSM off
automatically when driving or
braking in reverse.
When driving on surfaces with some traction, decrease the TSM
setting to allow the vehicle to feel more "loose" for power sliding,
drifting, and so on. On surfaces with very little traction (loose dirt,
smooth concrete, ice/snow), increase TSM to maximize acceleration
and control.
Drive with TSM on and off to test how it is making your control of
the vehicle easier and more precise. For more information, visit
Traxxas.com/tsm.
Note: TSM must be completely turned off while adjusting steering
trim.
SETTING UP THE
ANTENNA
The receiver antenna has been set up
and installed from the factory. The
antenna is secured by a 3x4mm set
screw. To remove the antenna tube,
simply remove the set screw with the
included 1.5mm wrench.
When reinstalling the antenna, first
slide the antenna wire into the bottom
of the antenna tube until the white
tip of the antenna is at the top of
the tube under the black cap. Next,
insert the antenna tube into the mount while making sure that the
antenna wire is in the slot in the antenna mount; then, install the set
Recommended setting
screw next to the antenna tube. Use the supplied 1.5mm wrench
to tighten the screw just until the antenna tube is securely in place.
Do not overtighten. Do not bend or kink the antenna wire! See the
sidebar for more information. Do not shorten the antenna tube.
Increase
assistance
www.modellmarkt24.ch
TRAXXAS TQ
RADIO SYSTEM
i
Antenna
Tip
Antenna
Tube
Antenna
Mount
To prevent loss of radio
range, do not kink or cut the
black wire, do not bend or
cut the metal tip, and do not
bend or cut the white wire at
the end of the metal tip.
Correct
No
No
No
XO-1
17
•
Publicité
