Publicité
Battery Compartment Specs:
• 49.5mm (1.95") wide x
155mm (6.10") long (stock)
or 135mm (5.31") long
• Height with stock strap:
23mm (.91") or 25mm (.94")
Note: There is some flex with
the battery strap. It is possible
to fit slightly taller batteries in
the compartment.
4 4
14
XO-1
•
TRAXXAS TQ
RADIO SYSTEM
i
INSTALLING & REMOVING THE BATTERY PACKS
The XO-1's battery
compartments can
accommodate a variety of LiPo
battery configurations. From
the factory, the compartments
are set up for Traxxas Power
Cell 5000mAh 3S packs. The
number on each side of the
hold-down indicates the battery
height in millimeters that the
hold-down can accommodate.
Note that one side is labeled
"23mm/38mm" and other side
is labeled "25mm/40mm".
Always remove the batteries
from the model before recharging.
Battery Compartment Height Chart
The chart below show the heights available through various hold-
down and retainer combinations. Parts in bold are sold separately.
Height (mm)
Hold-Down Part Number Retainer Part Number
20
#6426X
23
#6426
25
#6426
28
#6426X
35
#6426X
38
#6426
40
#6426
43
#6426X
Removing the Battery Packs
1. Unplug the High Current Connectors.
2. Flex the retainer away from the center of the chassis.
3. Lift up the battery hold-down, and pull it away from the chassis.
4. Repeat for the opposite battery.
www.modellmarkt24.ch
Installing the Battery Packs
1. Insert the battery into the tray with the High Current Connector
positioned towards the rear of the car.
2. Insert the hold-down into the lower set of holes in the center
support. If you are installing Traxxas Power Cell 5000mAh 3S
batteries, the hold-downs should be oriented so the side labeled
"25mm/40mm" is facing up.
3. Align the hold-down over the retainer and press down until it
snaps into place.
4. Repeat for the opposite battery.
5. When you are ready to drive, connect the High Current
Connectors to the speed control.
Adjusting The Battery Compartment Length
The XO-1's battery compartments
are configured for batteries that are
155mm long. The compartments'
rear battery cup can be moved
forward 20mm to accommodate
135mm battery packs. To configure
the compartments for 135mm packs,
remove the 3x10mm countersunk
screws, and reinstall the battery cup
using these screws in the rear set of
holes in the battery cup.
#6427
#6427
#6427
The Traxxas High Current Connector
#6427
Your model is equipped with the patented
#6427X
Traxxas High-Current Connector. Standard
#6427X
connectors restrict current flow and
#6427X
are not capable of delivering the power
#6427X
needed to maximize the output of brushless
power systems.
The Traxxas connector's gold-plated terminals with a large contact
surfaces ensure positive current flow with the least amount of
resistance. Secure, long-lasting, and easy to grip, the Traxxas
connector is engineered to extract all the power your battery
has to give.
Publicité
