Publicité
24
XO-1
•
MAINTAINING YOUR MODEL
Suspension and Cush Drive Assembly removal
Your model was designed with ease of disassembly in mind. The entire front and rear suspension assemblies can be removed from the
chassis fully intact with the removal of only a few screws. Refer to the exploded views included in the Service and Support Guide for
complete assembly diagrams.
• Removing the front suspension module
1. Remove the four 4x15mm countersunk screws from the underside of the chassis.
2. Remove the two 4x18mm button head screws from the front of the chassis brace.
3. Remove the 3x15mm button head screws from the steering servo horn.
4. Pull the front suspension assembly away from the chassis.
• Removing the rear suspension module
(Cush Drive Assembly removal)
1. Remove the two 3x25mm countersunk screws from the underside of the chassis.
2. Remove the two 3x15mm countersunk screws from the underside of the chassis.
3. Remove the two 4x12mm button head screws from the chassis brace.
4. Pull the rear suspension assembly away from the chassis.
5. Remove the Cush Drive (removing the two 3x10 button head screws that thread
into the motor mount through the chassis brace may help flex the chassis
brace out of the way).
3x15mm BCS
Front Suspension
Assembly
www.modellmarkt24.ch
4x12mm BCS
4x18mm BCS
3x15mm CCS
4x15mm CCS
Rear Suspension
Assembly
Cush Drive
Assembly
3x25mm CCS
Publicité
