Publicité
MN008401A01-AH
Chapter 13: Emergency Operation
If...
Emergency Call with Hot Mic
3. To exit Emergency Call, see
13.5
Sending Emergency Alarms with Emergency Calls
Procedure:
1. Press the programmed Emergency button.
Your radio shows the following indications:
●
The radio displays the confirmation message of a successful or unsuccessful acknowledgment
from the dispatcher.
●
The radio exits Emergency Alarm and enters the Emergency Call state.
●
The LED blinks orange momentarily
2. Perform one of the following actions based on the type of emergency call:
If...
Emergency Call
Emergency Call with Hot Mic
3. To exit Emergency Call, see
13.6
Receiving Emergency Alarms
When you receive emergency alarms, your radio shows the following indications:
●
The LED blinks red.
72
Then...
Speak into the microphone.
Exiting Emergency Operation on page
Then...
a. Press and hold the PTT button.
b. Speak into the microphone.
c. To end the transmission and wait for a
Speak into the microphone.
Exiting Emergency Operation on page
NOTE:
The Hot Mic applies to the first voice
transmission from your radio during
the Emergency call. For subsequent
transmissions in the same Emergency
call, you must press the PTT button.
73.
response from the dispatcher, release the
PTT button.
NOTE:
The Hot Mic applies to the first voice
transmission from your radio during
the Emergency call. For subsequent
transmissions in the same Emergency
call, you must press the PTT button.
73.
Publicité
