Publicité
7.A STEREO HUB SETTING UP
1.
3.
4.
1. Insert the batteries into your remote control
using the key provided. Be sure to respect the
polarities indicated.
2. Screw the antenna onto the Stereo Hub.
3. Select the tip corresponding to your mains
socket.
4. Then connect the power cable to your stereo
reo Hub. Do not connect the speaker power
cables at this time.
Do not connect the speaker power cables
at this time.
2.
SERVICE
5.
5. WAIT 1 minute for the Stereo Hub startup
sequence to complete. This sequence will
proceed as follows:
•
WISA LED off for 50 seconds.
•
WISA LED flashes for 20 seconds.
•
WISA LED off.
Turning off the WISA LED (on the back) of the
Stereo Hub will confirm the end of the se-
quence.
WISA
PAIRING
73
EN
Publicité
