Publicité
26
• Highlight "RESET ECU"
• The ignition key should be in the RUN position, with theengine off.
• Press "Continue".
• Highlight "WCM" and press "Continue".
• On the next screen press "Continue" one more time to reset the ECU.
• Press "Close" to exit procedure.
WINDOW CALIBRATION
NOTE: Vehicles equipped with the auto up feature must have the windows calibrated after a battery disconnect.
NOTE: The door must be completely closed when starting this step.
1. Sit in the driver seat and close the door.
2. Lower the window part of the way down.
3. Run the window to the full up position and continue to hold the switch for an additional two seconds.
4. Run the window to the full down position and continue to hold the switch for an additional two seconds.
5. Raise the window to the full up position.
6. Repeat the steps for the remaining windows.
TEMPORARY REMOTE START DISABLE
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "Totally integrated power module (TIPM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight and select "TEMPORARY REMOTE START DISABLE"
• Note OnScreen instructions and select the "NEXT" button
• Select the "DISABLE" button to activate the remote start function
• Select "YES" to reset the module and exit the routine, select "NO" to toggle the value back
• Select "FINISH"
Publicité
