Publicité
24
82. Push the edges of the instrument panel end cap trim
panel (1) to install. Make sure the snap retainers are
fully engaged. Repeat for the opposite side.
83. Install the glove box (1).
RESTORE VEHICLE CONFIGURATION
NOTE: The technician should have cut the KEY FOBIK Blanks using the original vehicle's Key FOBIK as a tem
plate. Please make sure the KEY FOBIK Blanks have been cut prior to programming. If this step has not been
performed, please perform at this time.
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Prior to programming, have the vehicle PIN readily available before running the routine. If necessary,
obtain the four digit PIN from the dealership's parts department.
CAUTION: If the PCM and WCM are replaced at the same time, the PCM MUST be programmed before the WCM.
1. When prompted, enter the four digit pin number obtained from the dealership parts department.
2. Connect a battery charger to the vehicle.
3. With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Highlight "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
Publicité
