Publicité
16
35. Continue routing the harness towards the driver side.
36. Remove the I/P to structure screw (1) located in the
top center of the I/P, pull gently on the center bracket
and push the harness behind it.
37. Install the I/P to structure screw (1). Tighten the screw
securely.
38. Attach tie strap (2) to I/P structure.
39. Route the harness (2) through to the instrument clus
ter area.
40. Attach a tie strap (2) to the instrument cluster
harnesses (1). Clip the excess off the end of the tie
wrap.
41. Finish routing the remote start antenna harness (2)
through to the steering column area near the wireless
control module (WCM) (1).
Publicité
