Publicité
Reset function/Safety cut-out
This appliance is equipped with a safety cut-out to protect the motor.
If fruit pieces get stuck and the appliance turns itself off, the safety cut-out has
tripped. The appliance switches itself off before the motor can be damaged due
to overheating.
The appliance cannot be switched back on until you reset the safety cut-out.
Proceed as follows to be able to use the appliance again:
Assembling and operating the appliance
■
Before using the appliance for the first time, clean all component parts
thoroughly as described in the section "Cleaning and care".
■
Install the appliance in accordance with the safety instructions.
►
Ensure that the plug on the power cable
assembling the appliance.
■
10
│
GB │ IE
Set the On/Off switch
–
power cable
out of the socket. Allow the appliance to cool down
for 10–15 minutes.
Turn the housing lid
–
towards the
marking on the sieve tray
Remove the housing lid
–
Remove the fruit or vegetable pieces causing the blockage.
–
Carefully remove the sieve tray
–
Insert the plug of the power cable
–
Press the RESET button
–
ance base
Pull the plug of the power cable
–
appliance base
Reassemble the appliance as described in the following section and
–
continue with juice extraction.
WARNING! RISK OF INJURY!
to the "O" position and pull the plug of the
anticlockwise until the
.
and turn the appliance base
into a mains socket.
that is on the underside of the appli-
.
out of the socket and turn the
over.
is not in the socket before
marking points
.
SSJBK 300 B2
over.
Publicité
