Disassembling Of The Lift; Checking The Service Light - Invacare Birdie Manuel D'utilisation

1. 2.
A
1. Open the carabiner A by pushing the safety catch B backwards
with one hand.
2. Hold the safety catch in the open position and attach the hanger
bar C to the upper part of the carabiner with the other hand.
3. Release the safety catch and move the hanger bar to the lower
point of the carabiner.

4.5 Disassembling of the lift

1. Remove optional leg spreader handle if attached.
2. Lower the boom and narrow both legs completely.
3. Activate the emergency stop button and apply castor brakes.
4. Remove the pipe pin and the motor piston from the boom,
reinstall the pipe pin in the piston end, and lock the motor into
the clips on the mast.
5. Attach the hanger bar into the welded fork on the mast.
6. Remove the locking pin from the base of the mast, release the
safety latch, lower the mast, and relocate the locking pin into the
mast near the suspension axle of the mast.
The lift can now be located in the packaging box, pulled on the
rear wheels, or parked in an upright position with the mast/boom
assembly pointing upwards.
1575480-B
3.

4.6 Checking the service light

( Jumbo Care control unit only)
1.
2.
CAUTION!
– Each time the lift is assembled, and before using the
lift, the service light should be checked.
– The service light should only be reset by a qualified
technician and must never be reset by untrained
personnel.
A
Examine the control box A to see if the service light C is flashing.
When service light is not flashing, the lift is ready for use.
When service light is flashing, refer to the table:
Setup
C
15