Publicité
Installation of the
system compon-
ents (overview)
Note! The following steps (1-6) are meant to provide you with an overview of
the start-up of the power source.
For more detailed information regarding the individual working steps please
refer to the User Manual TS 4000/5000 and TPS 2700/4000/5000 as well as
the user manuals of the corresponding system components.
4
6.
Place wire feeder
5.
Mount wire feeder mounting
4.
Mount gas cylinder holding device (the
"Duo" cylinder holding device is shown)
3.
Place power source on cooling unit:
-
Position power source above
cooling unit by means of a suitable
lifting device
-
Connect Molex plug of cooling unit
and power source
-
Fix power source to cooling unit
Fig.4
Connect Molex plug
2.
Mount cooling unit on carriage
1.
Assemble carriage
Publicité
