Publicité
EN
Charging
Before connecting to the mains, make sure that the mains
voltage corresponds to the specification on the charger's
rating plate.
Explanation of the indicator lights
When you insert the battery (1) into the charger (2)
the green indicator light (4) will begin to "BLINK".
This indicates that the battery is charging.
A continuous green indicator light (4) indicates
that the battery is fully charged.
A steady red indicator light (3) means that the
battery is outside the proper temperature ranges
(between 0°C and 35°C). As soon as it falls within the
correct temperature range, the charging process
will automatically begin.
If the red indicator light (3) is "BLINKING",
the contacts on the charger or battery are
contaminated, the battery is defective, or the
battery is not compatible with the charger. Clean
the contacts or replace the battery.
1
2
4
3
Plug charger cord into a standard power outlet (the charger's
green indicator light (4) will switch ON).
1.
Once the battery is fully charged, remove the battery
from the charger.
2.
Unplug the mains plug of the charger from the socket.
Indicator light
Constantly lit
=
Sufficient battery charge
Flashing (additional
=
Battery must be charged
warning tone)
32
PREPARATION
Preparation of the Coating Material
Using SprayPack 18V interior wall paints, varnishes and
glazes can be applied by spraying without diluting them, or
by diluting them slightly. Detailed information is available
in the technical data sheet of the manufacturer ( Internet
download).
1. Stir the material thoroughly and dilute it in the container as
per the recommended dilution (an agitator is recommended
for stirring).
Thinning recommendation
Glazes, wood preservatives containing
solvents or based on water, mordants,
oils, disinfection agents, plantprotective
agents
Paints containing solvents and
watersoluble paints, primers
Interior wall paint (dispersions and
latex paint)
* Observe the instructions of the paint manufacturer.
The values in the table are reference values.
The values in the table are reference values.
i
Find out how much the paint needs to be
Find out how much the paint needs to be
thinned by testing it.
thinned by testing it.
Make pump ready for operation
1) Make sure the inlet filter is in
place inside the hopper. If it is
not, snap in place as shown.
2) Press down the button on the
filter once. This will ensure
proper operation of the inlet
valve.
We recommend performing the
following steps with water first
of all, in order to check that the
system and all connections are
watertight.
3) Pull the latches down and
unhook them to remove the lid.
4) Fill your hopper with the
material you plan to spray.
Do not exceed the fill line as
shown. Pull the return hose
out of the container and hold
it over an empty container.
5) Turn the PRIME/SPRAY knob to
PRIME.
6) Insert the battery and set the
ON/OFF switch to the ON
position.
7) Slowly turn the speed control
clockwise to 2.
8) Check that the material is
flowing through the return
tube.
9) Switch the pump to OFF.
SprayPack 18V
undiluted*
dilute by 5 - 10 %*
dilute by 0-10 %*
Button
Publicité
