– The start or end of a corridor was
installed incorrectly
Remedy:
– Check LED on the docking station,
switch on the docking station if
necessary (
13.1)
– Check docking (
15.6)
– Check funnel-shaped entrance and exit
areas of the corridor (
Message:
1190 – Docking error
Docking station occupied
Possible cause:
– Docking station occupied by a second
robotic mower
Remedy:
– Dock robotic mower once docking
station is unoccupied again
Message:
1200 – Mowing motor fault
Mowing motor start not possible after 5
attempts
Possible cause:
– Dirt between carrier plate and mowing
deck housing
– Mowing motor cannot be switched on
– Mowing motor overloaded
Remedy:
– Clean mowing blade and mowing deck
(
16.2)
Clean carrier plate (
16.6)
– Set higher cutting height (
– Level out any uneven areas (holes,
depressions) in the mowing area
176
Message:
1210 – Drive motor fault
Wheel stuck
Possible cause:
– Overload at a drive wheel
Remedy:
– Clean robotic mower (
12.11)
– Level out any uneven areas (holes,
depressions) in mowing area
Message:
1220 – Rain detected
Mowing interrupted
Possible cause:
– Mowing operation has been interrupted
or not started due to rain
Remedy:
– No action necessary; adjust rain sensor
if required (
Message:
1230 – Docking error
Dock iMOW®
Possible cause:
– Docking station has been located,
automatic docking not possible
Remedy:
– Check docking, if necessary dock
robotic mower manually (
– Check perimeter wire – ensure correct
routing in area of docking station
(
9.9)
9.5)
16.2)
11.11)
15.6)
Message:
2000 – Signal problem
Dock iMOW®
Possible cause:
– Wire signal faulty, fine tuning necessary
Remedy:
– Place robotic mower in docking station
– then press OK
Message:
2020 – Recommendation
Annual service by spec. dealer required
Possible cause:
– Machine service recommended
Remedy:
– Have the annual service carried out by
a STIHL specialist dealer
Message:
2030 – Battery
Allowed operating time reached
Possible cause:
– Battery replacement necessary
Remedy:
– Have the battery replaced by a STIHL
specialist dealer
Message:
2031 – Charging failure
Check charging contacts
Possible cause:
– Charging cannot be started
Remedy:
– Check docking station and robotic
mower charging contacts and clean if
necessary – then confirm message with
OK
0478 131 9965 D - EN