Publicité
Removing the blade:
Push in both tabs (1) on the
carrier plate with one hand and
hold. Remove the fastening
nut (2) with your other hand.
Remove the mowing blade together with
the fastening nut.
Installing the mowing blade:
Risk of injury!
Check the blade for damage before
installation. The blade must be
replaced if notches or cracks are
identified or if its width is less than
25 mm, or its thickness is less than
1,3 mm at any point. (
The carrier plate and the
fastening nut must also be
replaced if damaged (e.g. broken,
worn). The fastening nut in
particular must engage cleanly in
the carrier plate.
● Clean the blade, carrier plate and
fastening nut prior to installation.
164
Fit the mowing blade (1) and fastening
nut (2) on the carrier plate (3) as
illustrated. Ensure the correct position of
the retainers (4) in the mowing blade.
16.3)
Screw on the fastening nut (1) as far as
possible. Several clicks are audible during
tightening. Ensure secure seating of the
mowing blade by shaking carefully.
● Following installation of a new mowing
blade, confirm the blade replacement in
the "Service" menu. (
16.5 Sharpening the mowing blade
Never re-sharpen blades.
STIHL recommends always replacing a
blunt blade with a new one.
Only new mowing blades are
balanced with the necessary
precision and guarantee proper
functioning of the machine as well
as low noise emissions.
16.6 Removing and installing the
carrier plate
The carrier plate can be removed in
order to clean the mowing deck.
● Activate the disabling
device (
5.2) and wear
protective gloves.
● Tilt the robotic mower onto its
side and lean it securely against a
stable wall. Carefully clean the mowing
deck and mowing blade. (
Removing the carrier plate:
● Remove the mowing blade. (
0478 131 9965 D - EN
11.17)
16.2)
16.4)
Publicité
