Publicité
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
– Perimeter wire routed inaccurately
Remedy:
– Check routing of the perimeter wire,
check clearances using the
iMOW® Ruler (
12.5)
Message:
1126 – Cancel teach-in
Teach-in failed
Remove obstacle
Possible cause:
– Obstacle in the area of the perimeter
wire
– Hood has been lifted
– Wire routing incorrect
Remedy:
– Free robotic mower, remove obstacle or
change routing of perimeter wire if
necessary
– Check movement of the hood
– Level out uneven areas
– Confirm the message with OK
– Restart teach-in run if necessary
Message:
1127 – Cancel teach-in
Teach-in failed
Possible cause:
– STOP button was pressed
– Allowed inclination exceeded
– Delete/save internal map of the mowing
area failed
– Docking was not successful
Remedy:
– Confirm the message with OK
– Restart teach-in run if necessary
0478 131 9965 D - EN
Message:
1128 – Direct drive home
Drive home on the wire aborted
Possible cause:
– Direct drive home could not be
successfully completed
Remedy:
– No action required, confirm message
with OK if necessary
– Contact your STIHL specialist dealer if
the problem persists
Message:
1130 – Stuck
Free iMOW®
then press OK
Possible cause:
– Robotic mower has become stuck
– Drive wheels are spinning
Remedy:
– Free robotic mower, level out mowing
area or change routing of perimeter
wire if necessary – then confirm
message with OK
– Clean drive wheels, if necessary
prevent operation during rain – then
confirm message with OK (
Message:
1135 – Outside
Place the iMOW® on the mowing area
Possible cause:
– Robotic mower is located outside
mowing area
Remedy:
– Return robotic mower to mowing area
Message:
1140 – Too steep
Check wire routing
Possible cause:
– Tilt sensor has detected a slope
inclination exceeding 40%
Remedy:
– Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 40%
Message:
1170 – No signal
Switch on docking station
Possible cause:
– Docking station is switched off
– No reception of wire signal during
operation
– Robotic mower is located outside
mowing area
– Docking station or electronic
components were replaced
Remedy:
– Switch on docking station and give
mowing command
– Check power supply to docking station
11.11)
– Check LED on docking station – the red
LED must be permanently illuminated
during operation (
– Return robotic mower to mowing area
– Link robotic mower and docking station
(
11.16)
Message:
1180 – Dock iMOW®
Automatic docking
not possible
Possible cause:
– The docking station was not found
13.1)
175
Publicité
