Stiebel Eltron SHF 2000 Utilisation Et Installation page 18

iNSTaLLaTiON
Configuration menu
f Insert the right side panel at the bottom and pivot the top
towards the appliance.
f Hook the top of the side panel into the cover and push it
backwards.
Make sure that the side panel rests on the mounting plate of
the programming unit.
f Secure the side panel using the 3 screws with serrated
washers.
f Before installing the front panel, remove the protective film
from the programming unit.
f Insert the front panel again.
f Secure the front panel using the screws with serrated
washers.
18 | SHF | SHS | SHL
f Tighten the air discharge grille with the two quarter-turn
locks.
13. Configuration menu
In the configuration menu, actual values and parameters are di-
vided into two access levels.
access Description
level
A0 Actual values and parameters that are enabled for the appliance
user and can be accessed without a code.
Parameters can be selected by pressing "+" or "-".
A1 Once you have entered a four-digit code, additional actual values
and parameters reserved for qualified contractors are enabled.
Parameters can only be selected by pressing "+".
To access the configuration menu, press and hold "Menu". After
approx. 3 seconds, actual value I1 is displayed.
Enabling actual values and parameters in access level A1
f Use "+" or "-" to call up the "CodE" menu item.
Access level A0 is displayed, alternating with the menu item.
f Press "OK".
The code entry field is displayed. The first digit flashes.
f Use "+" or "-" to enter the code 1 0 0 0.
After entering each digit, press "OK".
Once the code has been entered correctly, actual values and pa-
rameters that were previously inaccessible become visible.
To change the value of a parameter, use the "+" button to call up
the relevant parameter. Press "OK".
As soon as the "Editable parameter" symbol appears, you can
change the parameter value with "+" and "-". Press "OK" to save
the selected value.
If you press the "Menu" button or if no user action is performed
within 10 minutes, the appliance automatically switches to the
standard display. Parameter blocking is reactivated.
www.stiebel-eltron.com