Télécharger Imprimer la page

Parkside PSTKA 12 C3 Traduction Des Instructions D'origine page 34

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
GB
MT
Attaching and removing the
splinter guard
Attaching the splinter guard
1. Press the tension tear protection (24)
into the recess (25) in the slide shoe
(10).
Removing the splinter guard
1. Press the tension tear protection (24)
out of the recess (25) in the slide shoe
(10).
Checking the battery charge
level
LEDs
red, orange, green Battery charged
red, orange
red
Charging the battery
See also the charger instruction manual.
Notes
• If warm, allow the battery to cool be-
fore charging.
• Do not expose the battery to direct sun-
light for long periods and do not place
it on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (29) from the
device.
2. Push the battery (29) into the charging
slot of the battery charger (27).
3. Connect the battery charger (27) to a
power outlet.
34
When the device
is on, the battery
status indicator (6)
displays the battery
charge level.
Meaning
Battery partially
charged
Battery needs to be
charged
4. After charging, disconnect the battery
charger (27) from the mains.
5. Pull the battery (29) out of the battery
charger (27).
Operation
Information on sawing
Selecting a stroke rate
The stroke rate can be adjusted in 6 steps
via the rotary wheel (1). Start with a low
stroke rate. As a rule of thumb:
Material
Hard
Soft
Selecting the pendulum motion
The larger the pendulum motion, the faster
your progress.
The optimal pendulum motion can be es-
tablished through practice; the following
settings are recommended:
• For thin material, hard material (e.g.
metal) or for cutting curves: Level 0
• Fine and clean cutting edges can be
achieved with little or no pendulum mo-
tion: Level 0 or 1.
• Soft material (wood, plastic, etc.): Level
1 or 2
Plunge sawing
Requirements
• Soft materials such as wood, aerated
concrete, plasterboard etc.
• Mitre angle: 0°
• Maximum stroke rate selected (level 6)
• Short saw blade mounted
Procedure (Fig. F)
1. Place the device with the front edge of
the footplate (13) on the workpiece.
The saw blade (17) does not touch the
workpiece.
Stroke rate
Low
High

Publicité

loading

Ce manuel est également adapté pour:

426384 2301