Parkside PSTKA 12 C3 Traduction Des Instructions D'origine page 32

GB MT
viduals who wear medical implants should
consult their doctor and the manufacturer
of the implant before operating the ma-
chine.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
Control elements
Familiarise yourself with the operating ele-
ments before using the device for the first
time.
• On/Off switch (3)
• Switching on: Push forward
• Switching off: Pull backward
• Pendulum stroke switch (14)
Set pendulum movement of the saw
blade in 3 positions:
• 0 - no pendulum motion
• 1 - small pendulum motion
• 2 - medium pendulum motion
• Rotary wheel (1)
Set stroke rate in 6 levels.
Attaching and removing the
slide shoe
When working on scratch-sensitive work-
pieces, working with the slide shoe (10) is
recommended.
Assembling the slide shoe (Fig. A)
1. Place the slide shoe (10) on the front
of the footplate (13).
2. Press the notches (9) on the back of
the slide shoe over the footplate (13).
Disassembling the slide shoe
(Fig. A)
1. Press the slide shoe (10) on the
notches (9) away from the footplate
(13).
32
2. Pull the slide shoe (10) forward, away
from the footplate (13) and off.
Attaching and removing the
saw blade
CAUTION! Risk of injury
when touching the saw blade.
Wear protective gloves when
handling the saw blade.
Requirements
• The saw blade is suitable for the re-
spective material.
• The chuck is free of splinters or other
material residue.
Installing the saw blade (Fig. B)
1. Turn the release of the chuck (22) as
far as possible. Keep the release of the
chuck fixed in this position.
2. Place the saw blade (16/17) into the
chuck (21).
3. Release the release of the chuck (22)
los.
4. Make sure that the saw blade (16/17)
is attached correctly and the teeth are
pointing in the cutting direction.
Removing the saw blade (Fig. B)
Hold the device in a way that no persons
in the vicinity are injured by the ejected
saw blade.
1. Hold the saw blade (16/17) firmly.
2. Turn the release of the chuck (22) as
far as possible.
The saw blade (16/17) is ejected.
If the saw blade is not ejected: Hold
the release of the chuck and pull the
saw blade from the chuck.
3. Release the release of the chuck (22)
los.
Using the parallel guide
The parallel guide can be fitted on both
sides of the tool.