Publicité
Les langues disponibles
Les langues disponibles
Before operating the disc sanding device,
you must secure it against tipping.
Securing the disc
B
sanding device
Secure the disc sanding device horizon-
tally (
) or vertically (
surface.
The enclosed screw clamp (16) must grip
into one of the two receptors (4).
Mounting / dismounting
the sanding table
Dismounting the sanding table:
1. Release the screw (9) underneath the
sanding table (11) using the hexagon
socket wrench enclosed (17).
2. Remove the screw (9) and the washer
(8) and pull the sanding table holder
(10) away from the device.
Mounting the sanding table:
3. To mount the sanding table (11), push
the sanding table holder (10) back
onto the device.
4. Insert the screw (9) with washer (8) and
tighten.
Ensure the 4 lugs are correctly po-
sitioned (see illustration
wise screw (
Replacing sanding paper
Caution! Risk of injury! Discon-
nect the device from the power sup-
ply to prevent unintentional starting.
To make it easier to replace, first
dismount the sanding table (11)
and holder (10) (see "Dismounting/
mounting the sanding table").
) to the working
) other-
9) will not screw in.
Attaching sanding sheet:
1. Press the sanding sheet (18) evenly
onto the sanding disc (1).
Removing sanding sheet:
2. Remove the sanding sheet (18) from the
sanding disc (1).
Trial run:
Perform a trial run at top speed without a
load for at least 1 minute whenever you
change the sanding paper. Remain outside
the hazard area while doing so.
Setting the sanding
table angle
The angle of the sanding table (11) can be
adjusted continuously between -10° and
+50°.
1. Loosen the screws (7).
2. Set the desired angle via the knurled
nut (
19) using the angle scale (6).
3. Tighten the screws (7).
Using an angle stop
1. Loosen the angle stop screw (13b).
2. Slide the rail of the angle stop (13a)
into the desired position in the groove
(12) on the sanding table (11).
3. Set the desired angle using the scale
onto the rail marking (13a).
4. Fix the angle stop (13) in place by
tightening the screw (13b).
Connecting external dust
extraction
Please check the operating manual
of your vacuum cleaner to ascertain
whether it is suitable for the suction
of grinding chips.
GB
IE
23
Publicité
