Parkside PTSG 140 C2 Traduction Des Instructions D'origine page 18

GB IE
Scope of delivery
Unpack the device and check for complete-
ness. Dispose of the packaging material
properly.
- Disc sanding device
- Sanding disc
- Screw clamp
- Angle stop
- 6 x sanding paper + carrier film
- 2x granulation 80
- 2x granulation 150
- 2x granulation 240
- Angle adapter and adapter for exter-
nal dust extraction
- Hexagon socket wrench
- Operating instructions
Description of functions
Please refer to the descriptions below for
information about the operating devices.
Overview
1 Sanding disc
2 Speed regulator
3 On/off switch
4 Receptor for screw clamp
5 Mains plug
6 Angle scale
7 Screw for angle locking
8 Washer
9 Screw for fixing sanding table
10 Sanding table holder
11 Sanding table
12 Slot for angle stop
13 Angle stop
13a Angle stop rail
13b Angle stop screw
14 Angle adapter for external dust
extraction
18
15 Adapter for external dust
extraction
16 Screw clamp
17 Hexagon socket wrench
18 Sanding paper
19 Knurled nut
Technical Data
Disc sander ................ PTSG 140 C2
Rated input voltage ..........230 V~, 50 Hz
Power input .............140 W (S2 15 min)*
Idling speed (n ) ..............max. 3600 min
0
Safety class ..................................... II
Protection category...........................IPX0
Weight ....................................... 2,4 kg
Sanding disc diameter ................ 125 mm
Sound pressure level
(L ) ................... 63,2 dB(A); K
pA
Sound power level (L
measured .......... 76,2 dB(A); K
* After continuous operation of 15 minutes the
drill stops until the device temperature devi-
ates by less than 2 K (2 °C) from the room
temperature.
Levels of noise were determined according
to the norms and regulations in the decla-
ration of conformity.
Notes on safety
CAUTION! When using power
tools, observe the following basic
safety measures for the prevention
of electric shocks and the risk of
injury and fire.
Please read all these instructions
before using this electric tool and
please keep the safety instructions.
= 3 dB
pA
)
WA
= 3 dB
WA
-1