Parkside PTSG 140 C2 Traduction Des Instructions D'origine page 24

GB IE
Connecting external dust
extraction:
1. Place the angle adapter (14) into the
opening on the device.
Ensure that you slide the lug on the
angle adapter (14) into one of the two
slots in the device opening (see de-
tailed illustrations).
2. Rotate the angle adapter (14) into a
vertical or horizontal position to secure
the angle adapter (14) against falling
out.
Removing external dust
extraction:
3. Gently turn and pull on the angle
adapter (14) to remove it.
It can be removed when the arrow on
the angle adapter (14) and the mark-
ing on the device housing are exactly
aligned.
An additional adapter (15) with a
larger diameter is provided with the
device and this can, if required, be
attached to the angle adapter (14).
If necessary, you can connect the
suction hose of a vacuum cleaner
directly onto the angle adapter.
Operation
Before initial operation, perform a trial run
at top speed without a load for at least 1
minute. Remain outside the hazard area
while doing so.
Switching on and off
Make sure that the power supply
voltage matches the voltage rat-
ing indicated on the device's type
plate.
24
Connect the machine to the power
supply.
1. Select the desired speed using the
speed regulator (2).
Switching on:
2. Press the power switch "I" (3), the de-
vice starts.
Switching off:
3. Press the off switch „O" (3), the device
turns off.
4. Next, remove the mains cable (5) from
the wall socket.
After switching on the device, wait until the
device has reached its max. speed. Only
then may you commence sanding.
Sanding
The arrow
( 1) indicates the direction of rotation of
A
the disc sanding device.
The sanding speed can be regulated using
the speed regulator (
Mounting horizontally (
• Place the workpiece on the sanding
table (11) and slowly bring it to the de-
sired angle towards the left half of the
sanding disc (
A
Mounting vertically (
• Slowly bring the workpiece to the de-
sired angle towards the sanding disc
( 1).
A
Dismantle the sanding table (11)
before starting to sand in a vertical
position (see "Dismantling/mount-
ing the sanding table").
above the sanding disc
2).
A

):
1).

):