Casselin CFRPCD40 Mode D'emploi page 76

ALARMS
CRITICAL ALARM
These alarms prevent any oven adjustments until they are reset. If the cooking
function is in START, it is automatically deactivated in STOP.
Coded Description
E-0 CONFIGURATION ERROR. A few
Seconds after startup, the alarm is displayed
indicating the I/O board firmware versions and
settings.
E-1
CONNECTION BETWEEN KEYBOARD
AND CARD
Lack of communication between screen and
power board
SAFETY THERMOSTAT.
E-2
No voltage on AT input terminal 55
E-27 E-5 COMPARTMENT COMPARTMENT
TEMPERATURE.
Overheating (greater than P122) of the NTC
probes of the keyboard and/or the power card.
E-4 3 ROOF/FLOOR/TOP PROBE
E-48 4
FAILURE.
E-37 18
This alarm appears if the probe is
- short-circuited
- interrupted
- Out of measurement range
RESTARTING AFTER A POWER
FAILURE
This alarm appears when restarting after a power
cut during cooking. The recipe data is retrieved
and the oven automatically resumes cooking, at
from the last step of the current recipe before
the power cut.
TOO LONG TIME IN POWER
OUTAGE
If the time elapsed in the event of a power outage
(from power outage to voltage recovery) exceeds
parameter P207 (expressed in minutes), the
oven restarts with this alarm and goes into
standby.
NON-SUSPENSIVE ALARM
These are alarms which are displayed but which do not suspend cooking
E 19 Stationary band. Only possible if P294 = 0
27
Reset
Manual
Automatic, when
communication between the
base and the keyboard is
reestablished.
Automatic, when voltage is
detected at the input,
the alarm resets.
Automatic, when voltage is
detected at the input, the
alarm resets.
This alarm is automatic reset,
which means that if the cause
of the fault is eliminated, the
oven will automatically reset.
Automatic reset alarm,
disappears when
the band is put back
into motion.
Furnace reactions
In the event of a serious
error, no action is possible
In case of cooking, it goes
into STOP mode, otherwise
no action is possible
In case of cooking, it goes
into STOP mode, otherwise
access to
service is possible.
When cooking, it goes into
STOP mode, otherwise
access to the service is
possible.
When cooking, the oven
goes into STOP mode
If, during cooking, the
strip remains still for
longer than P298