Publicité
Les langues disponibles
Les langues disponibles
SilverCrest SPWD 180 I1
8.4 Replacing the batteries
Replace the batteries when they are empty. To replace the
lithium batteries CR2032, remove the cover of the battery
compartment (7) at the rear of the diagnostic scales by
inserting a finger into the recess of the battery compartment
(7). Then lift the battery compartment (7) cover upwards and
remove it.
To remove the batteries, push them down a bit (see the
direction of the arrow in the illustration). You can then remove
the batteries from the holder.
Then insert two new CR2032 lithium batteries. Always pay
attention to the polarity. This is indicated in the battery
compartment (7), and the + symbol on the CR2032 lithium
batteries must be visible, as shown in the adjoining illustration.
Next insert the battery compartment (7) cover back to its
original position. The diagnostic scales are now ready to use.
9. Troubleshooting
9.1 Nothing is indicated on the display
•
The CR2032 lithium batteries are empty. Replace the CR2032 lithium batteries with new ones
of the same type. Please note the instructions in the "Replacing the batteries" section.
•
The CR2032 lithium batteries are inserted incorrectly. Please note the instructions in the
"Replacing the batteries" section.
9.2 "Lo" is indicated on the display and the scales switch off
•
The CR2032 lithium batteries are almost empty. Replace the CR2032 lithium batteries with
new ones of the same type. Please note the instructions in the "Replacing the batteries" section.
30 - English
Your input data are stored permanently and will not be lost when replacing
the batteries.
Publicité
