SilverCrest SPWD 180 I1 Mode D'emploi Et Consignes De Sécurité page 30

SilverCrest SPWD 180 I1
8.1 Switching on the scales / measuring weight
Due to the step on power function, the diagnostic scales are switched on automatically when you
step on the tread (5) and they start to measure your weight immediately.
In their original state, the diagnostic scales are set to the "kg" (11) unit of weight. Once the selected
unit of weight is displayed, press the buttons ▲ (2) or ▼ (4) to change it. The selected unit of weight
is then indicated on the display (1).
Stand on the tread (5) of the diagnostic scales so that your weight is evenly distributed. Remain as
still as possible during the weighing process as the measurement result may be distorted otherwise.
The measurement result is indicated on the display (1) during the weighing process. The measurement
is complete when the display flashes.
8.2 Switching on the scales / measuring weight, BMI,
recommended calorie intake and body fat, water, bone and
muscle percentages
You must first enter your personal data before performing these measurements. Please pay particular
attention to the section "Entering or changing personal data". Proceed as follows to perform the
measurement:
•
Briefly step on the scales to switch them on.
•
Press the SET (3) button to enter diagnostic mode.
•
Press the ▲ button (2) and ▼ button (4) to select the desired user profile memory (19).
•
Stand barefoot on the tread (5) and make sure that you are standing on the electrodes (6).
•
The user profile memory (19) flashes several times. The age and body height set are displayed
one after the other before the measurement of body weight begins. After the body weight is
displayed flashing, measurement of the other values begins. Stay on the electrodes (6) until
measurement is complete. During the weighing and measurement process, try to stay as still as
possible to ensure an accurate result.
28 - English
The diagnostic scales must be calibrated before first use or after having been
moved to ensure that they can determine one's weight exactly. To do so, step
briefly on to the tread (5), step off it again and wait until the diagnostic scales
switch off automatically. The diagnostic scales are now calibrated.