Parkside PTS 710 B2 Mode D'emploi page 46

Type/Description
Diamond-coated cutting
saw blade
23 Z89
Ø 89 mm
TCT saw blade
26 Z89/30
Ø 89 mm
30 teeth
˜ Markings for cutting line
The viewing window for the cutting line helps
you accurately guide the product along the
cutting line on the workpiece.
For a true-to-size cut, place the product
o
onto the workpiece so that the cut marking
appears in the viewing window for the cutting
line .
[ ]
˜ Connecting the sawdust
extractor
NOTE
When working on wood for long periods
u
of time, and especially when working
on materials that generate dust that is
hazardous to health, connect the unit to an
external dust extraction device suitable for
the material.
Check that the dust extraction unit is
u
correctly attached.
Also observe the operating instructions for
u
the dust extraction device .
Observe the regulations valid in your
u
country for the materials to be processed.
Push the suction hose
u
extractor connection
place.
Attach an approved dust and sawdust
u
extractor to the suction hose.
Application
Ceramics
o
Stone
o
Wood
o
Plastic
o
onto the dust
[ ]
and lock it in
[ ]
˜ Changing the saw blade
m WARNING! RISK OF INJURY!
Always remove the power plug from
the mains power socket before carrying
out any work on the product.
1. Actuate the spindle lock
key to loosen the tensioning screw
[ ]
(turn clockwise to open). Remove the
tensioning screw and the clamping flange
(see also Fig. B).
2. Set the cutting depth to the maximum position.
3. Activate the safety lock-out
in that position. Swivel the base plate
upwards.
4. Remove the saw blade
5. Fit the saw blade in the reverse order as
described above.
6. Press the spindle lock button (until it engages)
and use the hex key to tighten the tensioning
screw.
The arrow on the saw blade must
o
correspond to the arrow showing the direction
of rotation (running direction shown on
the product).
˜ Switching the laser on and off
Switching on
Press the Laser on/off switch
o
Switching off
Press the Laser on/off switch
o
NOTE
If the battery is depleted, replace it with a
u
new 3 V button cell (type CR2032).
Have the carbon brushes replaced by the
u
manufacturer, its customer service or a
similarly qualified person.
Always keep the area around the protective
o
hood clean. Remove dust and shavings with a
brush or compressed air.
and use the hex
[ ]
[ ]
[ ]
and keep it
2 ] [
7 ] [
.
[ ]
.
[ ]
again.
[ ]
GB/IE 45