Parkside PTS 710 B2 Mode D'emploi page 44

DANGER OF EXPLOSION!
Never recharge non-rechargeable
batteries. Do not short-circuit batteries/
rechargeable batteries and/or open
them. Overheating, fire or bursting can
be the result.
Never throw batteries/rechargeable batteries
into fire or water.
Do not exert mechanical loads to batteries/
rechargeable batteries.
Risk of leakage of batteries/
rechargeable batteries
Avoid extreme environmental conditions and
temperatures, which could affect batteries/
rechargeable batteries, e.g. radiators/direct
sunlight.
If batteries/rechargeable batteries have
leaked, avoid contact with skin, eyes and
mucous membranes with the chemicals! Flush
immediately the affected areas with fresh
water and seek medical attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries/
rechargeable batteries can cause burns
on contact with the skin. Wear suitable
protective gloves at all times if such an
event occurs.
In the event of a leakage of batteries/
rechargeable batteries, immediately remove
them from the product to prevent damage.
Remove batteries/rechargeable batteries
if the product will not be used for a longer
period.
Risk of product damage
Only use the specified type of battery/
rechargeable battery!
Insert batteries/rechargeable batteries
according to polarity marks (+) and (–) on
the battery/rechargeable battery and the
product.
Use a dry lint-free cloth or cotton swab
to clean the contacts on the battery/
rechargeable battery and in the battery
compartment before inserting!
Remove exhausted batteries/rechargeable
batteries from the product immediately.
˜ Operation
˜ Inserting/replacing the
battery
1. Open the battery compartment cover
a Phillips screwdriver.
2. If necessary, remove the used battery.
3. Insert a new 3 V button cell (type CR2032)
in accordance with the polarity shown. Screw
the lid of the battery compartment cover back
on.
m CAUTION!
If operating and adjustment equipment
u
is used or procedures other than those
specified here are carried out, this may
result in hazardous radiation exposure.
NOTE
The product is equipped with a power on/
u
control lamp , which lights up green as
[ 5 ]
soon as the product is connected to the
mains. This action indicates that the product
is live.
˜ Check base plate/blade guard
m WARNING! RISK OF INJURY!
Always remove the power plug from
the mains power socket before carrying
out any work on the product.
Check the freedom of movement of the base
o
plate before each use.
7 ] [
Activate the safety lock-out
o
that position. Lower the circular saw. In this
way, you can test the function of the base
plate. The base plate must move freely and
may not jam.
After letting go, it must be move smoothly
o
back to its starting position of its own accord.
with
[ ]
and keep it in
2 ] [
GB/IE 43