Parkside PTS 710 B2 Mode D'emploi page 42

Take special care when working
d)
near corners, sharp edges, etc.
Avoid allowing the accessory tool
to bounce back from the workpiece
or jam. The rotating accessory tool is more
likely to jam in corners or sharp edges or if it
bounces. This can cause a loss of control or
kickback.
Do not use a toothed or chain saw
e)
blade or a segmented diamond-
coated disc with more than 10 mm
wide slits. Such accessory tools cause a
kickback or loss of control over the power
tool.
Avoid cutting disc jams or excessive
f)
contact pressure. Do not make any
excessively deep cuts. Overloading
the cutting disc increases the stress and
likelihood of tilting or blocking and thus the
possibility of a setback or a breakage of the
grinding tool.
If the cutting disc jams or you stop
g)
working, switch the tool off and
hold it steady until the disc has
completely stopped turning. Never
attempt to pull a rotating cutting
disc out of a cut. This could lead to
kickback. Identify and remove the cause
of the jam.
Do not switch the power tool back
h)
on as long as it is in the workpiece.
Allow the cutting disc to reach its full
i)
speed before you carefully continue
the cut. Otherwise, the disc may jam, jump
out of the workpiece or cause kickback.
Support panels or large workpieces
j)
to reduce the risk of the cutting disc
jamming and causing a kickback.
Large workpieces can bend under their own
weight. The workpiece must be supported on
both sides, namely in the vicinity of the cut
and also at the edge.
Be particularly careful when
k)
making pocket cuts into existing
walls or other obscured areas. The
inserted cutting disc may cut into gas or
water pipes, electrical wiring or other objects
that can cause kickback.
˜ Supplementary notes
Approved cutting disc designs
Diamond-coated, disc diameter 89 mm, disc
thickness max. 1.8 mm
Always wear a dust mask!
Always wear ear muffs!
Original accessories/auxiliary
equipment
Use only the accessories and additional
equipment that are specified in the operating
instructions and are compatible with the
appliance.
Cutting saw blade (symbols)
m WARNING!
Wear ear muffs!
Wear safety goggles!
Wear safety shoes!
Wear protective gloves!
Wear a dust mask!
Not approved for wet grinding!
Approved diameter of tools
Not approved for side grinding
GB/IE 41