Parkside PTS 710 B2 Mode D'emploi page 39

˜ Specific safety instructions for
this saw
Function of the blade guard
Before every use, check to ensure
a)
that the blade guard closes
properly. Do not use the saw if the
blade guard does not move freely
and does not close immediately.
Never jam or fasten the blade
guard; this would leave the saw
blade unprotected. If the saw is
accidentally dropped, the blade guard may
be bent. Ensure that the blade guard moves
freely and does not touch the saw blade or
other parts at any cutting angles or depths.
Check the condition and function
b)
of the spring for the blade guard.
Have the saw serviced before using
it if the blade guard and spring are
not working properly. Damaged parts,
sticky deposits or accumulations of chippings
can cause the lower blade guard to operate
slowly.
When making a "plunge cut" that is
c)
not at right angles, secure the base
plate of the saw to prevent any
lateral movement. Lateral movement can
cause the saw blade to jam, thus causing a
kickback.
Do not leave the saw on the work
d)
bench or floor if the blade guard is
not fully covering the saw blade.
An unprotected, coasting saw blade will
move the saw in the opposite direction to the
cutting direction and saw anything in its path.
Always, take into account that the saw blade
takes some time to stop spinning.
38 GB/IE
˜ Supplementary notes
Do not use any grinding discs.
Use only saw blades with diameters
corresponding to the label on the saw.
When working with wood or materials
that produce dust hazardous to health, the
appliance must be connected to a suitable,
tested extraction appliance.
Wear a dust mask when sawing wood.
Only use recommended saw blades.
Always wear ear muffs.
Avoid overheating the sawtooth tips.
When sawing plastic, avoid melting the
plastic.
Use the correct saw blade according to the
material to be sawn.
Use only saw blades specified by the
manufacturer which, if intended for cutting
wood or similar materials, comply with
EN 847-1.
Tools may only be used by trained and
experienced persons who are familiar with
the use of tools.
Circular saw blades with torn bodies must be
taken out of service (repair is not permitted).
The maximum speed indicated on the tool
must not be exceeded. If specified, the speed
range must be observed.
Circular saw blades (symbols)
m WARNING!
Wear protective gloves!
Wear a dust mask!
Wear safety goggles!
Wear ear muffs!