PLAYTIVE 435256 2304 Notice D'utilisation page 35

8. Starting at point 0, insert a spring (12) into the free 7th eyelet (6a) and opening. Count another 14 eyelets (6a)
and openings further and insert the next spring (12). Repeat this until you have returned to point 0.
9. Starting at point 0, insert a spring (12) in every 4th eyelet (6a) and opening. Count another 7 eyelets (6a) and
openings further and insert the next spring (12). Repeat this until you have returned to point 0.
10. Insert the remaining springs (12) into the remaining eyelets (6a) and openings in any order you choose. If you
have missed an eyelet (6a) or opening, check which spring (12) has been attached incorrectly and reattach it in
the correct position.
7.3 Attaching the frame padding
The frame padding (7) ensures safety and protects users from the springs (12). It must be carefully installed so that
no injuries can occur while jumping and/or falling. Proceed as follows:
1. Place the frame padding (7) on the jump mat (6) so that the springs (12) and frame poles (1) are covered.
2. Hook the rubber bands (7a) of the frame padding (7) to the eyelets (6a) of the jump mat (6) opposite them,
around the frame poles (1).
3. Take the cord (13) and knot one end of the cord (13) onto one of the eyelets (6a) of the jump mat (6).
4. Thread the other end of the cord (13) through the tab (7b) of the frame padding (7).
5. Thread the cord (13) back through the next eyelet (6a) of the jump mat (6).
Note
After threading the cord (13), pull it taut in one of the fifth to tenth eyelets (6a).
6. Repeat steps 4 and 5 until you have threaded the cord (13) once through all the eyelets (6a) of the jump mat (6)
and tabs (7b) of the frame padding (7).
7. Fasten the ends of the cord (13) into a firm knot.
7.4 Installing the safety net
The safety net (10) is fastened to the net poles with holder (4) by a ring. The ring consists of the ring poles (9) and
connectors (8) that are joined together and threaded into the safety net (10).
Proceed as follows:
1. Spread out the safety net (10) on the jump mat (6).
Note
The entrance opening of the safety net (10) must not be located over a foot.
2. Place a connector (8) on one end of a ring pole (9).
Note
The slot in the connector (8) must be facing upwards and the screw holes of the ring poles (9) and connectors (8)
must be aligned.
3. Screw the connector (8) to the ring pole (9) with a small screw (14) and a small nut (19). Use the hex key/
screwdriver (20) and the tool (21).
GB/IE 35