PLAYTIVE 435256 2304 Notice D'utilisation page 139

4. Repeat steps 2 and 3 until you have threaded the cord (13) once through all the eyelets (6a) of the jump mat (6)
and tabs (7b) of the frame padding (7).
5. Fasten the ends of the cord (13) into a firm knot.
STEP 8-12
1. Spread out the safety net (10) on the jump mat (6).
Note
The entrance opening of the safety net (10) must not be located over a foot.
2. Place a connector (8) on one end of a ring pole (9).
Note
The slot in the connector (8) must be facing upwards and the screw holes of the ring poles (9) and connectors (8)
must be aligned.
3. Screw the connector (8) to the ring pole (9) with a small screw (14) and a small nut (19). Use the hex key/
screwdriver (20) and the tool (21).
Note
The ring poles (9) and the connectors (8) must slide into each other easily and must not jam.
4. Repeat this step seven times.
5. Guide the ring poles (9) through the top openings in the safety net (10) with the connectors (8) leading.
WARNING!
Always guide a ring pole (9) through the openings of the safety net (10) with the connector (8) leading. Otherwise
the sharp-edged ends of the ring pole (9) may damage the safety net (10).
Note
Each opening of the safety net (10) must contain a ring pole (9) with connector (8) and the end of the next ring
pole (9).
6. Connect the ring poles (9) by inserting the free end of the next ring pole (9) into the connector (8).
7. Firmly screw the end of the ring pole (9) into the connector (8) with a small screw (14) and a small nut (19). Use
the hex key/screwdriver (20) and the tool (21).
Note
Two adults should perform the next step of fastening the net poles (3) to the frame and the feet.
Note
The net pole (3) must arch outwards.
8. Hold two spacers (16) on each drill hole of the leg sleeve (1a) and the foot.
5. ATTACHING THE FRAME PADDING
6. INSTALLING THE SAFETY NET
GB/IE 29