6. INSTALLING THE SAFETY NET
Note
The spacers (16) have two different sides for a large and a small pipe diameter. The more pronounced arch (smaller
diameter) must be pointing towards you.
9. Place the net pole (3) with its drill holes in front of the spacers (16) and insert one large screw (15) through each
drill hole in the leg sleeve (1a) and the foot.
10. Place a washer (17) on the end of the large screw (15) and tighten the large nut (18) with the tool (21) and the
hex key/screwdriver (20).
11. Repeat the previous steps seven times.
12. Place the ring poles (9) on the net poles with holder (4).
13. With two people standing opposite one another, lift the safety net (10) on the net poles with holder (4) and
place the open end of the net poles with holder (4) onto the ends of the net poles (3).
7. ATTACHING THE SAFETY NET
STEP 13
1. Start near the entrance and fasten all rubber bands (10c) on the safety net (10) to the eyelets (6a) of the jump
mat (6).
Note
The zip fastener (10a) on the safety net (10) must be closed.
8. OPENING/CLOSING THE SAFETY NET
WARNING!
Before getting on the trampoline, make sure that there are no persons, animals or objects on or under the trampo-
line! There is a risk of injury to the animal as well as the user!
WARNING!
Do not jump off the trampoline.
1. Open the safety fastener (10b) and then the zip fastener (10a) on the safety net (10) in order to get onto the
trampoline.
2. Close everything before jumping and after getting off the trampoline.
30
GB/IE