PLAYTIVE 435256 2304 Notice D'utilisation page 33

6. Selecting a location
• The trampoline is not suitable for indoor use.
• Carefully select the location of the trampoline. The trampoline must not be set up over hard surfaces.
• The trampoline must not be set up on smooth surfaces, such as tiles! It could slip!
• Set up the trampoline on a level surface at least 2m away from other structures and obstacles such as fences,
garages, houses, protruding branches, washing lines or electrical lines. Make sure that there is sufficient room
above the trampoline. Do not set it up near windows, walls, trees, etc. There should be a clear space of at least
7.5m above the trampoline.
• The trampoline must not be set up on concrete, asphalt or similarly hard surfaces, or near structures where there
is potential for collision, such as paddling pools, swing sets, slides, jungle gyms, etc.
• The trampoline must not be embedded in the ground.
• Set up the trampoline in a safe location so that it cannot blow away or tip over!
• Locate the trampoline so that others cannot use it unsupervised, and secure it against unauthorised use!
7. Assembly
Remove all parts from the packaging outdoors and check whether all parts are present. If this is not the case, please
contact our customer service.
WARNING!
Due to its size, the trampoline must be assembled and installed by at least two adults.
WARNING!
Wear protective gloves when assembling the trampoline and make sure that you are working deliberately and care-
fully. Make sure that you do not get caught in any parts! There is a risk of injury!
Note
Use the separate assembly instructions for assembly. These present the necessary information on the individual steps
visually.
Note
Self-locking nuts are used for the assembly. These are suitable for one-time use only and must be replaced after
being removed.
7.1 Assembling the base frame
The base frame must be assembled using multiple frame poles (1). Proceed as follows:
1. Select a suitable location for the trampoline. You can find more information in section '6. Selecting a location'.
2. Place the frame poles (1) on the ground with the openings facing upwards.
3. Connect the frame poles (1) in succession such that the opening of the leg sleeve of the connector (1a) is point-
ing downwards.
4. Connect the frame poles (1) to create a closed circle.
GB/IE 33