PLAYTIVE 435256 2304 Notice D'utilisation page 137

STEP 1
WARNING!
Due to its size, the trampoline must be assembled and installed by at least two adults.
WARNING!
Wear protective gloves when assembling the trampoline and make sure that you are working deliberately and care-
fully. Make sure that you do not get caught in any parts! There is a risk of injury!
1. Place the frame poles (1) on the ground with the openings facing upwards.
2. Connect the frame poles (1) in succession such that the opening of the leg sleeve of the connector (1a) is point-
ing downwards.
STEP 2
1. Connect the frame poles (1) to create a closed circle.
Note
The ends of the frame poles (1) must be completely inside the connector (1a).
STEP 3
1. Connect one bracket pole (2) and two extension poles (5) to create one foot; repeat until you have made four
feet.
Note
They must CLICK audibly when being fastened. The pin of the bracket pole (2) is then correctly locked into the pin
hole of the extension pole (5).
STEP 4
1. Insert the ends of the four feet into the leg sleeves of the frame poles (1).
STEP 5
1. Spread out the jump mat (6) inside the circle of the base frame. Make sure that the marking on the jump mat (6)
is facing upwards.
WARNING!
Be careful when inserting the springs (12)! The springs (12) are under tension during insertion! There is a risk of
injury!
WARNING!
Take care when inserting the springs (12) and follow the instructions below precisely so that the jump mat (6) is set
up properly. Otherwise there is a risk of injury!
3. ASSEMBLING THE BASE FRAME
4. INSTALLING THE JUMP MAT
GB/IE 27