Publicité
Les langues disponibles
Les langues disponibles
Install a FoodSaver
See FIG. 1
1.
Pull open the built-in roll storage door in the back of the
appliance.
2.
Insert the roll into the back of the appliance as pictured.
3.
Open up appliance lid fully so that it stays in place.
4.
Thread end of roll forward through the opening on the back
between lid and appliance. pull through the appliance until the
end of roll is at the front edge.
5.
See next section for how to make a bag from a FoodSaver Roll.
Make a Bag from a FoodSaver
(Express Bag Making)
See FIG. 2
1.
Press Power Button to turn appliance on. Power button and
default mode selection will illuminate.
2.
Once Roll is installed and appliance lid is fully opened, thread
end of roll forward through the opening on the back between lid
and appliance.
3.
Pull roll down just past the Sealing Strip.
4.
Using two hands, pull down appliance lid (from the all the way up
position) and with both hands firmly press down both sides of lid
until appliance begins to automatically close and lock.
5.
Press Seal Button, sealing the end of the bag will begin. Button
light will pulse until complete and then light will turn off.
6.
Appliance lid will automatically open once seal is complete.
7.
Pull out now sealed end of roll to length of bag desired.
8.
Again, using both hands firmly press down both sides of lid, until
appliance begins to automatically close and lock.
9.
Before using cutter bar to cut this first bag, press Seal Button to
seal end of next bag.
10. While appliance is sealing the next bag, cut first bag by sliding
the built-in Cutter Bar.
TIP: After making this first bag from the roll, if the above steps are
followed, the seal should already be made for the next bag. Each time
you seal, you are making the seal for the next bag while using cutter
bar to cut the current bag.
11. After finished making bag(s) from roll, open built-in roll storage
door in the back of appliance and manually roll up the excess roll
that may still be inside the appliance, so that no roll or material is
left inside the appliance.
12. Close Built-in Roll Storage and Door.
7
Roll
®
Roll
®
www.foodsavereurope.com
Vacuum Seal with FoodSaver
See FIG. 3
1.
Press Power Button to turn appliance on. Power button and
default mode selection will illuminate.
2.
With both hands, slowly insert the open end of filled bag through
the bottom of the Vacuum View Window into Drip Tray.
NOTE: The appliance lid should Not be completely open.
HINT: If having trouble getting bag inside appliance, wiggle it from
side to side while inserting.
IMPORTANT TIP: When inserting open end of filled bag, center the
bag in the middle of the appliance for best results. The Vacuum View
Window allows you to easily see where the end of the bag is when
inserting. Continue to insert and hold bag until appliance automatically
detects and lid closes and locks.
3.
The appliance will automatically detect bag insertion & Appliance
Lid close and lock. Bag Detected indicator light will blink then
become steady to confirm the bag has automatically been
sensed. Vacuum and Seal Button Lights will blink.
CAUTION: Lid closes down automatically. Remove hands or any
other objects that may be obstructing the lid before closing. Do not
manually force the lid to close.
4.
Select desired Vacuum Mode (Dry, Moist, Liquid, or Sous Vide)
depending on the food that is being vacuum sealed by pressing
Mode Button. Indicator light will illuminate next to selected mode.
5.
Once desired mode is selected, press Vacuum Button to begin
vacuum sealing process. Vacuum Button light will pulse until
complete.
6.
After vacuum is complete, Vacuum button light will go steady and
appliance will automatically begin sealing. Seal Button light will
pulse until complete.
7.
Once vacuumed and sealed, vacuum and seal button lights will
go steady then turn off. Appliance lid will automatically open and
release the bag.
8.
Refrigerate, freeze or store as needed. (See "Guidelines" for
food storage safety tips on pg 9.)
IMPORTANT TIP: At any time during vacuum sealing, the Cancel
Button can be pressed and the appliance lid will open automatically.
When Dry and Moist lights flash, the drip tray is full. Please empty
it. Vacuum and Seal function will function normally after drip tray is
emptied.
Use FoodSaver
®
Containers
To Vacuum Seal
See FIG. 4
1.
Prepare accessory according to FoodSaver
Guidelines, included with accessory purchases.
2.
Press Power Button to turn appliance on. Power button and
default mode selection will illuminate.
3.
Pull out the Built-In Retractable Handheld Sealer to desired
length.
CAUTION: When pulling hose Do Not extend beyond red line marked
on hose.
Bags
®
Preserve & Marinate
Accessory
®
Publicité
