Reflex Hydroflow Mode D'emploi Original page 38

Commissioning
6.4 Electrical connection
DANGER
Risk of serious injury or death due to electric shock.
If live parts are touched, there is risk of life-threatening injuries.
•
Ensure that the supply cable to the device is disconnected and secured
against being switched back on.
•
Ensure that the system is secured and cannot be reactivated by other
persons.
•
Ensure that installation work for the electric connection of the device is
carried out by an electrician, and in compliance with electrical locally
applicable electrical engineering regulations.
The following descriptions apply to standard systems and are limited to the
necessary user-provided connections.
1. Disconnect the system from the power source and secure it against
unintentional reactivation.
2. Remove the cover.
DANGER Risk of serious injury or death due to electric shock. Some
parts of the device's circuit board may still be live with 230 V even after the
device has been physically isolated from the power supply by pulling out of
the mains plug. Before you remove the covers, completely isolate the
device controller from the power supply. Verify that the main circuit board
is voltage-free.
3. Install a screwed cable gland suitable for the respective cable. M16 or
M20, for example.
4. Thread all cables to be connected through the cable gland.
5. Connect all cables as shown in the terminal diagram.
–
For installer supplied fusing, comply with the connected loads of the
device ,  5 "Technical data",  31.
6. Install the cover.
7. Connect the mains plug to the 230 V power supply.
8. Activate the system.
The electrical connection is completed.
6.4.1 Terminal diagram
The mains water station is completely pre-assembled and pre-wired at the
factory. Connect the mains cable for commissioning.
6.5 Installation and commissioning certificate

Note!
The installation and commissioning certificate can be found at the end
of the operating manual.
38 — English
7
7.1
•
•
•
•
7.2
Check all system components for leaks. If there are any leaks, seal them
accordingly. Adjust the test pressure and the test duration to the respective
pipework system and the respective operating pressure.
Reflex Hydroflow Mains Water Station — 20.12.2023
Commissioning
Note!
Contract an authorised specialist company for installation,
commissioning and maintenance.
Checking the requirements for commissioning
The mains water station has been mounted on a wall or on the hot water
storage tank with accessories.
The water connections to the system circuit are established.
The system circuit is filled with water and gas-vented.
The electrical connection has been created according to applicable
national and local regulations.
Leak testing