MicroPower SX Serie Manuel D'utilisation page 7

Charging
WARNING
RISK OF ELECTRIC SHOCK!
Do not use the battery charger if it is damaged.
Disconnect the mains immediately.
Do not touch damaged parts, uninsulated battery
terminals, connectors, or other live electrical
parts.
Contact service personnel.
Connect and start charging
1. Check the cables and connectors for visible
damage.
2. Connect the mains cable. The mains indicator
lights up blue when the mains is connected.
3. Connect the battery charger to the battery.
The BMS controls the charging process. If
•
charging curve is used, the charging
process starts automatically.
The charging status is shown on the
•
display on the control panel and by the
charging indicators (LED indication).
LED indication
Li-ion with CAN control
Green double
Green
flashing
Charging in pro- Equalize
gress. The num- charging
ber of green (balancing) in
LEDs indicates progress.
the progress of
the charge
cycle.
For a detailed description, see the section LED
indication.
Stop charging and disconnect
RISK OF MATERIAL DAMAGE!
Do not disconnect the battery when the charging
process is in progress. Arc flash may occur and
damage the connector pins. Always stop the
charging process before the battery is
disconnected.
1. Stop the battery charging process by pressing
2. While stopped, disconnect the battery charger
Green On Red and green
Charging com- An alarm is
pleted. active, but
charging is still
in progress.
Green LEDs indicate that the battery is
•
fully charged. The battery charger
continues with maintenance charging.
• The battery can be continuously connect-
ed to the battery charger when not in use.
CAUTION
the Pause button on the battery charger
control panel.
The charging process can be resumed by
pressing the Pause button again.
from the battery.
Yellow
Red On
flashing
Charging An alarm is
paused. A bat- active.
tery is connect- Charging is
ed, but charg- stopped.
ing is paused
(due to e.g.
Stop input).
ENGLISH
Red flashing
Software mal-
function.
7