MicroPower SX Serie Manuel D'utilisation page 5

Check that the power supply at the site of the
•
installation complies with the rated voltage
specified on the battery charger's data label.
• The battery charger may only be connected to
a power outlet with protective earth.
• Do not operate the charger if there is any
evidence of damage.
• If the supply cord or plug is damaged, the
manufacturer, its service agent, or similarly
qualified persons must carry out any
replacement of the cord / plug in order to
avoid a hazard.
If a stationary appliance is not fitted with a
•
supply cord and a plug, or with other means
for disconnection from the supply mains,
disconnection must be incorporated in the
fixed wiring in accordance with the national
wiring rules.
WARNING, risk of electric shock.
High output voltage. Do not touch
uninsulated battery terminals, con-
nectors, or other live electrical parts.
When installing or performing work on battery,
charger, and battery terminals – do not risk short
circuits. A short circuit may cause personal injury
and permanently damage the battery. For all work
on battery chargers, batteries and battery
systems, suitable insulated tools must be used.
Warning information
Hazardous situations and precautions are
presented in the text as follows.
WARNING
Indicates a potentially dangerous situation. Death
or serious injury may occur if appropriate precau-
tions are not taken.
CAUTION
Indicates a situation where damage or injury
could occur. If it is not avoided, minor injury
and/or damage to property may result.
NOTE
General information not connected to safety for
person or the product.
Graphical symbols
The following graphical attention symbols may
appear on the products and in the documentation.
Read the instructions. The manual
contains important safety and oper-
ating instructions.
Stop operation. Always stop the
charging by pressing the Pause
button before any disconnection.
WARNING, risk of electric shock.
High voltage inside. High output
voltage. Do not touch uninsulated
battery terminals, connectors, or
other live electrical parts.
CAUTION, undesirable conse-
quences. The situation needs
operator awareness or action.
For indoor use only. The battery
charger is designed only for indoor
use unless the charger is at least
IPX4-rated.
Wear protective gloves. The
battery cables / battery connectors
may become hot during charging.
Introduction
This document contains use and maintenance
instructions for the intended battery charger.
This document is of relevance for the one who
uses the battery charger for its purpose; charge
batteries.
Target groups:
Installers
•
Operators
•
Maintenance personnel and technicians
•
Description
The MICROPOWER SX is a stand-alone battery
charger for lithium-ion (Li-ion) batteries,
compatible with Micropower GET System through
Bluetooth communication. As standard, the
charger is also equipped with a display, radio
ENGLISH
5