Publicité
Les langues disponibles
Les langues disponibles
EN
ESC/Receiver Arming and Battery Installation
Arming the ESC/receiver also occurs after binding as
previously described, but subsequent connection of a ight
battery requires the following steps.
AS3X
The AS3X
®
system will not activate until the throttle stick
is increased above 25% for the rst time. Once active,
the control surfaces may move rapidly and noisily on the
aircraft. This is normal. AS3X technology will remain active
until the battery is disconnected.
1. Open the battery hatch by lifting from the rear.
2. Attach the battery to the hook and loop strip so the
battery is centered in the battery cavity.
3. Lower the throttle and power on your transmitter. En-
able throttle cut switch.
4. Connect the battery to the ESC, noting proper polarity.
Keep the plane immobile and away from wind for 5
seconds to allow the AS3X system to initialize. A series
of tones and a continuous LED (LED may be dif cult
to see as it is located inside the aircraft.) indicates a
successful connection.
A solid blue LED indicates that the aircraft is in SAFE
ight mode, and a solid RED LED indicates that the
aircraft is in AS3X ight mode. When the aircraft is in
SAFE the servos will move without increasing throttle
above 25%.
5. Replace the battery hatch.
CAUTION: Always disconnect the Li-Po battery
from the ESC when not ying to eliminate power
supplied to the motor. The ESC does not have an
arming switch and will respond to any transmitter input
when a signal is present.
CAUTION: Always disconnect the Li-Po battery
from the ESC when not ying to avoid
over-discharging the battery. Batteries discharged to a
voltage lower than the lowest approved voltage may
become damaged, resulting in loss of performance and
potential re when batteries are charged.
Center of Gravity (CG)
The CG location is 44mm ± 4mm behind the leading
edge of the wing at the root. This CG location has been
determined with the recommended battery. Check the CG
with the model inverted. Adjust the battery forward or aft
so the model balances level at the recommended point.
www.modellmarkt24.ch
8
44mm from leading edge +/-4mm
UMX Me 262 BNF Basic
Publicité
