Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting Guide
Problem
LED on receiver ashes
rapidly and aircraft will
not respond to transmit-
ter (after binding)
Control surface does
not move
Controls reversed
Motor loses power
Motor power quickly
decreases and in-
creases then motor
loses power
Motor/ESC is not armed
after landing
Servo locks or freezes
at full travel
www.modellmarkt24.ch
Possible Cause
Less than a 5-second wait between rst
powering on transmitter and connecting
ight battery to aircraft
Aircraft bound to different model memory
(ModelMatch
™
radios only)
Flight battery/transmitter battery charge is
too low
Transmitter may have been bound to a
different model (or with a different DSM
Protocol)
Aircraft or transmitter is too close to large
metal object, wireless source or another
transmitter
Control surface, control horn, linkage or
servo damage
Wire damaged or connections loose
Flight battery charge is low
Control linkage does not move freely
Transmitter settings reversed
Damage to motor or power components
Battery power is down to the point of
receiver/ESC Low Voltage Cutoff (LVC)
Over Current Protection (OCP) stops the
motor when the transmitter throttle is set
high and the fan/rotor cannot turn
Travel adjust value is set above 100%,
overdriving the servo
Solution
Leaving transmitter on, disconnect and
reconnect ight battery to aircraft
Select correct model memory on transmitter
and disconnect and reconnect ight battery
to aircraft
Replace/recharge batteries
Select the right transmitter or bind to the
new one
Move aircraft and transmitter to another
location and attempt linking again
Replace or repair damaged parts and adjust
controls
Do a check of wires and connections, con-
nect or replace as needed
Fully recharge ight battery
Make sure control linkage moves freely
Adjust controls on transmitter appropriately
Do a check of motor and power components
for damage (replace as needed)
Recharge ight battery or replace battery that
is no longer performing
Fully lower throttle and throttle trim to
arm ESC
Set Travel adjust to 100% or less and/or set
sub-trims to zero and adjust linkages
mechanically
EN
15
Publicité
