Publicité
Les langues disponibles
Les langues disponibles
Differences Between SAFE and AS3X Modes
This section is generally accurate but does not take into account ight speed, battery charge status, and other limiting
factors.
Control stick is
neutralized
Holding a small
amount of control
Holding full control
Disabling and Enabling SAFE Select
By default, the SAFE Select function of your UMX aircraft is
enabled and assigned to the gear channel switch (channel
5). If you do not wish to have access to SAFE Select while
ying, you can choose to disable SAFE Select functionality.
AS3X will still be active when SAFE Select is disabled.
IMPORTANT: Before attempting to disable or enable SAFE
Select, ensure the aileron, elevator, rudder, throttle and
gear channels are all on high rate with the travel set to
100%. Turn throttle hold OFF if it is programmed in the
transmitter.
1. Power on the transmitter.
2. Power on the aircraft.
3. Hold both transmitter sticks to the inside bottom
corners and toggle the Gear switch 5 times (1 toggle =
full up and down). The control surfaces of the aircraft
will move, indicating SAFE Select has been enabled
or disabled.
Repeat the process to disable or enable or disable SAFE
Select. The aircraft will cycle both ailerons up and down to
indicate a change has been made.
DXe and DXS Transmitters
Switch A is the FMODE switch on the these transmitters,
and the switch needs to be toggled between position 0
and 2 when disabling/enabling SAFE Select.
www.modellmarkt24.ch
SAFE Select
Aircraft will self level
Aircraft will bank or pitch to a moderate angle and
maintain the attitude
Aircraft will bank or pitch to the predetermined
limits and maintain the attitude
AS3X
Aircraft will continue to y at its
present attitude
Aircraft will continue to pitch or
roll slowly
Aircraft will continue to roll or pitch
rapidly
Mode 1 and 2 Transmitters
100%
x 5
100%
EN
7
Publicité
