Publicité
Les langues disponibles
Les langues disponibles
EN
AS3X
System Trouble Shooting Guide
®
Problem
Control surfaces not at
neutral position when
transmitter controls are
at neutral
Model ies inconsis-
tently from ight to
ight
Controls oscillate in
ight, (model rapidly
jumps or moves)
Troubleshooting Guide
Problem
Aircraft will not respond
to throttle but responds
to other controls
Extra fan/rotor noise or
extra vibration
Reduced ight time or
aircraft underpowered
LED on receiver ashes
and aircraft will not bind
to transmitter (during
binding)
www.modellmarkt24.ch
14
Possible Cause
Control surfaces may not have been
mechanically centered from factory
Aircraft was moved after the ight battery
was connected and before sensors
initialized
Aircraft was not kept immobile for 5
seconds after battery was plugged in
Trims are moved too far from neutral
position
Fan/rotor is unbalanced, causing excessive
vibration
Fan/rotor screw is loose, causing vibration
Possible Cause
Throttle stick and/or throttle trim too high
Throttle channel is reversed
Motor disconnected from receiver
Damaged fan/rotor, spinner or motor
Fan/rotor screw is loose
Fan/rotor is out of balance
Flight battery charge is low
Fan/rotor installed backwards
Flight battery damaged
Flight conditions may be too cold
Battery capacity too low for ight conditions Replace battery or use a larger capacity
Transmitter too near aircraft during binding
process
Bind switch or button not held long enough
during bind process
Aircraft or transmitter is too close to large
metal object, wireless source or another
transmitter
Solution
Center control surfaces mechanically by
adjusting the U-bends on control linkages
Disconnect and reconnect the ight battery
while keeping the aircraft still for 5 seconds
Keep the aircraft immobile for 5 seconds after
plugging in the battery
Neutralize trims and mechanically adjust
linkages to center control surfaces
Remove fan/rotor and rebalance or replace it
if damaged
Tighten the fan/rotor screw
Solution
Reset controls with throttle stick and throttle
trim at lowest setting
Reverse throttle channel on transmitter
Open fuselage and make sure motor is
connected to the receiver
Replace damaged parts
Tighten the fan/rotor screw
Remove and balance fan/rotor, or replace
with a balanced fan/rotor
Completely recharge ight battery
Install fan/rotor with numbers facing forward
Replace ight battery and follow ight battery
instructions
Make sure battery is warm before use
battery
Power off transmitter, move transmitter a
larger distance from aircraft, disconnect and
reconnect ight battery to aircraft and follow
binding instructions
Power off transmitter and repeat bind pro-
cess. Hold transmitter bind button or switch
until receiver is bound
Move aircraft and transmitter to another
location and attempt binding again
UMX Me 262 BNF Basic
Publicité
