Publicité
Les langues disponibles
Les langues disponibles
EN
Low Voltage Cutoff (LVC)
When a Li-Po battery is discharged below 3V per cell, it
will not hold a charge. The aircraft's ESC protects the ight
battery from over-discharge using Low Voltage Cutoff
(LVC). Once the battery discharges to 3V per cell, the
LVC will reduce the power to the motor in order to leave
adequate power to the receiver and servos to
land the airplane.
When the motor power decreases, land the aircraft im-
mediately and replace or recharge the ight battery.
Always disconnect and remove the Li-Po battery from
Transmitter Setup
If your transmitter allows it, enable the throttle cut feature.
Always engage throttle cut before approaching the aircraft.
Dual Rates
Low rate is recommended for the initial ights.
NOTICE: To ensure AS3X
do not lower rate values below 50%.
NOTICE: If oscillation occurs at high speed, refer to the
Troubleshooting Guide for more information.
1. Power ON your transmitter, click on scroll wheel, roll to System Setup and click the scroll wheel.
Select YES.
2. Go to Model Select and choose Add New Model near the bottom of the list.
Select Airplane Model Type by choosing airplane image, select Create.
3. Set Model Name: Input a name for your model le.
4. Go to Aircraft Type and scroll to the wing selection, choose Wing: Normal Tail: Normal
5. Select Main Screen, Click the scroll wheel to enter the Function List.
6. Go to D/R (Dual Rate) and Expo menu to set D/R and Expo.
7. Set Rates and Expo: Aileron
Set Switch: Switch F
Set High Rates: 100%, Expo 10% — Low Rates: 70%, Expo 5%
8. Set Rates and Expo: Elevator
Set Switch: Switch C
High Rates: 100%, Expo 10% — Low Rates 70%, Expo 5%
9. Set Rates and Expo: Rudder
Set Switch: Switch G
High Rates: 100%, Expo 10% — Low Rates 70%, Expo 5%
10. Set Throttle Cut; Switch: Switch H, Position: -100%
www.modellmarkt24.ch
4
®
technology functions properly,
NX Series Transmitter Setup
the aircraft after each ight. Charge your Li-Po battery to
about half capacity before storage. Make sure the battery
charge does not fall below 3V per cell. Failure to unplug a
connected battery will result in trickle discharge.
For your rst ights, set your transmitter timer or a stop-
watch to 5 minutes. Adjust your timer for longer or shorter
ights once you have own the model.
NOTICE:
Repeated ying to LVC will damage the
battery.
Exponential
After your initial ights, you may adjust the exponential
value to better suit your ying style.
Telemetry Settings
Smart ESC : Low Voltage Alarm 3.4V
Smart Battery : Startup Volt Minimum 4.0V
UMX Me 262 BNF Basic
Rx V : Min Rx V 4.2V
Motor Pole Count 8
Publicité
