Publicité
Les langues disponibles
Les langues disponibles
4
Supply line Connection
Warning
Air hoses which are installed with a hose grommet must be additonally secured with
a hose clamp.
Design: Gravity-feed cup
1.
Connect the air hose to the air pipe (cleaned com-
pressed air) or on an air cleaner and on the air
inlet of the spray gun.
2.
Fill the cup with screened material. Close the cup.
3.
Switch on the pneumatic system.
The spray gun can be taken into operation.
Design: Material connection
1.
Connect the compressed air hose to the air line
(cleaned compressed air) or to an air cleaner and
to the compressed air connection (item 24) on the
spray gun.
2.
Connect the material feed hose to the material
pressure tank or the material pressure regulator of
a pumping system and to the material feed con-
nection (item 27) on the spray gun.
3.
Fill material into the material pressure tank and
close the cover.
4.
Set the desired material pressure on the com-
pressed air reducing valve; if the material is sup-
plied via pump systems, the material pressure is
set on the material pressure regulator by means of
an adjustment key.
5.
Open the material valve on the pressure tank.
6.
To allow the air in the material hose to escape,
operate the trigger, until a uniform material spray
exits the nozzle; the gun can now be closed again.
The gun is now ready to be operated.
5
Operational Handling
The following requirements must be met before the spray gun can be put into ope-
ration:
The material pressure may not be set higher than 8 bar. The air pressure must not
exceed 8 bar.
1.
Before using the gun, first carry out a spray pattern test. The spray pattern can
best be tested on a sample workpiece or on a sheet of metal, cardboard or
Air connection
Air connection
28
Material-
connection
Publicité
