WALTHER PILOT PILOT Trend V1060103 3 Serie Mode D'emploi page 21

EC/EU Declaration of Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility
that the product(s) described below conform to the essential safety requirements. This
declaration will be rendered invalid if any changes are made to the equipment without
prior consultation with us.
Manufacturer
Type Designation
Intended purpose
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006/42/EC
2014/34/EU (ATEX Directives)
DIN EN ISO 12100:2011-3
DIN EN 1953:2013
Specification according 2014/34/EU
Category 2
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the
provision of the Directives 2006/42/EC.
Wuppertal, 31 January 2020
p.p.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety
instructions provided in the product documentation must be observed at all times.
WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Manual Spray Guns PILOT Trend
PILOT Trend
PILOT Trend
PILOT Trend-MP Gravity-Feed Cup
PILOT Trend-MP Material Connection
Processing of sprayable media
Part marking
Gravity-Feed Cup
Material Connection
DIN EN 1127-1:2019
DIN EN ISO 80079-36:2016
II 2G Ex h IIC T6 Gb
21
V1060103xx3
V1060203xx3
V1061104xx3
V1061304xx3
Tech.File,Ref.:
2413