WALTHER PILOT PILOT Trend V1060103 3 Serie Mode D'emploi page 27

Measures must be taken to ensure that the spray gun is sufficiently grounded
(earthed) by means of a conductive air hose (maximum resistance 10
Before carrying out maintenance or servicing work, always ensure that the air and
material feed to the spray gun have been depressurised. Risk of injury!
When spraying materials, do not place your hands or other parts of the body in front
of the pressurised nozzle or the spray gun. Risk of injury!
Never point the spray gun at persons or animals. Risk of injury!
Always observe the spraying and safety instructions given by the manufacturers of
the spraying material and the cleaning agent. Aggressive and corrosive materials in
particular can be harmful to health.
Exhaust air containing particles (overspray) must be kept away from the working
area and personnel. In spite of these measures, always wear the regulation brea-
thing masks and protective overalls when using the gun. Airborne particles represent
a serious health hazard!
Always wear hearing protection when using the gun or when in the vicinity of a gun
that is in use. The noise level generated by the spray gun is approx. 83 dB (A).
After carrying out assembly or maintenance work, always ensure that all nuts, bolts
and screw connections have been fully tightened before the gun is used.
Use only original replacement parts, since WALTHER can only guarantee safe and
fault-free operation for original parts.
For further information on the safe use of the spray gun and the spraying materials,
please contact WALTHER Spritz- und Lackiersysteme GmbH, D-42327 Wuppertal,
Germany.
3 Technical Description
PILOT Trend:
Model version:
PILOT Trend-MP: Manual spray gun for medium pressure
Model version:
The spraying pressure is 1.2 to 1.4 bar with an input pressure of 3.0 to 3.3 bar
The material flow rate is dependent on the diameter of the nozzle and the adjustment
of the material pressure at the pressure tank or material pressure regulator. In addi-
tion, the material flow rate can be controlled by screwing the adjusting screw (N° 18)
in or out. For further adjustment possibilities, see Section 6. Changing the Spray
Pattern.
Manual spray gun for conventional atomisation
• with gravity-feed cup
• with material Connection
• with gravity-feed cup
• with material Connection
27
Ω).
6