Installation And Connection - Bartscher BETA Mode D'emploi

5.2 Installation and connection

CAUTION!
Installation and maintenance can only be performed by qualified personnel!
Setup
•
Unpack the device and remove all packing material.
•
Place the device on a flat, secure surface that can support its weight and is resistant
to high temperatures.
•
Never place the device on a flammable surface.
•
Do not place the device near an open flame, electric or coal oven, or other heat
source.
•
Place the device in a well-ventilated area. The device may only be installed in a
space with proper ventilation, optimally under an oven hood that will direct fumes to
the outside.
•
Ensure that ventilation openings are not blocked in any way.
•
Do not place the device directly against walls or other objects made of flammable
material.
•
Keep a minimum distance of
300 mm from the ceiling if it is
made of flammable material or
does not have heat insulation.
•
To enable installation and
maintenance, keep a distance
of at least 500 mm between the
device's right side and walls or
other device (see diagram at
right).
•
Keep a minimum distance of
100 mm on the left side and at
the rear of the device from
walls or other objects, and
150 mm from the top.
- 35 -