Publicité
Les langues disponibles
Les langues disponibles
STARTING AND STOPPING
Check before starting
S Check the blade to ensure that no cracks
have formed at the bottom of the teeth or
by the centre hole. The most common rea-
son why cracks are formed is that sharp
corners have been formed at the bottom of
the teeth while sharpening or that the blade
has been used with dull teeth. Discard a
blade if cracks are found.
WARNING:
Use of an incorrect
or damaged blade could result in
serious injury or death. Always dis-
card a blade that is bent, twisted,
cracked, broken or damaged in any
other way. Never attempt to straight-
en a twisted blade so that it can be
reused. Only use original blades of
the specified type.
S Check that the support flange is not
cracked due to fatigue or due to being
tightened too much. Discard the support
flange if it is cracked.
S Ensure the blade retainer nut has not lost
its captive force. The nut lock should have
a locking force of at least 1.5 Nm. The
tightening torque of the blade retainer nut
should be 35- -50 Nm.
S Check that the trimmer head and trimmer
guard are not damaged or cracked.
Replace the trimmer head or trimmer
guard if they have been exposed to
impact or are cracked.
115158126 Rev. 8 5/15/12
All manuals and user guides at all-guides.com
S Never use the machine without a guard
nor with a defective guard.
S All covers must be correctly fitted and un-
damaged before you start the machine.
Starting and stopping
WARNING:
The complete clutch,
clutch cover, and shaft must be
fitted before the machine is started,
otherwise parts could come loose
and cause personal injury.
Always move the machine away
from the refueling area before
starting. Place the machine on a
flat surface. Ensure the cutting at-
tachment cannot come into contact
with any object.
Make sure no unauthorized
persons are in the working area,
otherwise there is a risk of serious
personal injury. The safety
distance is 50 feet (15 meters).
Cold engine
Primer bulb: Press the primer bulb 10
times until fuel begins to fill the bulb. The
primer bulb need not be completely filled.
Choke: Move the blue engine choke lever
over to the closed position.
Starting
Hold the body of the machine on the
ground using your left hand (CAUTION!
Not with your foot!).
Firmly grip the starter rope handle with
your right hand. DO NOT squeeze
throttle trigger. Slowly pull out the cord
until you feel some resistance (the starter
pawls grip); then quickly and powerfully
pull the cord.
Never wrap the starter cord around
your hand.
English--- 16
Publicité
