Publicité
Les langues disponibles
Les langues disponibles
NOTE:
Make sure unit is assembled cor-
rectly as shown in this manual.
Fitting the handlebar
S Remove the screw at the rear of the
throttle handle.
S Slide the throttle handle onto the right
side of the handlebar (see illustration).
S Align the screw hole in the throttle han-
dle with the hole in the handlebar.
S Refit the screw in the hole in the rear of
the throttle handle.
S Thread the screw through the handle
and handlebar. Tighten the screw.
S Position the handle bar as shown. Fit the
mounting components as shown.
S Put on the harness and hang the machine
from the harness clamp. Now make a final
adjustment so that the machine is in a
comfortable working position when it hangs
from the harness. Tighten the knob.
115158126 Rev. 8 5/15/12
All manuals and user guides at all-guides.com
ASSEMBLY
Fitting the harness
WARNING:
brushcutter, it must always be
hooked securely to the harness.
Otherwise, you will be unable to
control the brushcutter safely.
This can result in injury to yourself
or others. Never use a harness with
a defective quick release.
Proper harness and handlebar adjust-
ments must be made with the engine com-
pletely stopped before using unit.
Adjusting the harness
S At the front of the harness is an easily
accessible quick release. Use the quick
release in any emergency situation that
requires you to free yourself from the
machine and harness.
Spreading the load on your
shoulders
S A well- -adjusted harness and machine
makes work much easier.
S Put on the harness. Adjust the harness
for the best working position. Tension the
side straps so that the weight is evenly
distributed across both shoulders.
When using a
English--- 11
Publicité
