Metz MECABLITZ 58 AF-1 N digital Mode D'emploi page 103

7.5 Cordless remote mode (Remote)
• When „Remote OFF" appears, the cordless remote mode is deactivated.
• When „Remote Master" appears, the flash unit is operating as a guiding
master flash unit on the camera.
• When „Remote Slave" appears, the flash unit is operating completely as a
slave flash unit. See also Section 21.
Setting procedure:
• Press the „SEL" button repeatedly until „Select" appears on the display.
• Select the „Remote" menu option by pressing the UP
tons. The selected menu option will be highlighted.
• Confirm the selection of the special function by pressing the „Set" button.
• Select the desired setting with the UP
ting takes effect immediately.
• Press the „Return" button repeatedly until the screen is reset to its nor-
mal view. If the „Return" button
cally reset to its normal view after about 5 seconds.
7.6 Meter-Feet changeover (m/ft)
The maximum flash range indicated by the flash unit's display can either be
shown in meters or feet. The setting can be adjusted under the menu option
m/ft. Setting procedure:
• Press the „SEL" button repeatedly until „Select" appears on the display.
• Select the „m/ft" menu option by pressing the UP
tons. The selected menu option will be highlighted.
• Confirm the selection of the special function by pressing the „Set" button.
• Select the desired setting with the UP
ting takes effect immediately.
- When „m" is displayed, distances will be shown in meters.
- When „ft" is displayed, distances will be shown in feet.
• Press the „Return" button repeatedly until the display is reset to its nor-
and DOWN
and DOWN buttons. The set-
is not pressed, the display is automati-
and DOWN but-
and DOWN buttons. The set-
mal state. If the „Return" button
cally reset to its normal view after about 5 seconds.
7.7 Secondary reflector
The secondary main reflector
indirect light when the main reflector is swivelled down (see 10.3). If the
secondary reflector produces too much light, it can be reduced to 1/2 or
1/4 .
• „ Off" setting: Secondary reflector is turned off.
• „ P1 / 1" setting: secondary reflector is operating at full light output.
but-
• „ P1 / 2" setting: secondary reflector is operating at 1/2 light output.
• „ P1 / 4" setting: secondary reflector is operating at 1/4 light output.
When the secondary reflector is activated and the setting is saved, a symbol
will appear in the display.
Setting procedure:
• Press the „SEL" button repeatedly until „Select" appears on the display.
• Select the menu option
The selected menu option will be highlighted.
• Confirm the selection of the special function by pressing the „Set" button.
• Select the desired setting with the UP
ting takes effect immediately.
• Press the „Return" button
mal state. If the „Return" button
cally reset to its normal view after about 5 seconds.
Please also refer to the information in Section 10.3!
7.8 Modelling Light (ML)
The modelling light is a high-frequency stroboscopic flash. It creates the
impression of a semi-permanent light for a duration of about 3 seconds. The
modelling light enables the user to assess light distribution and the formation
of shadows before taking pictures.
is not pressed, the display is automati-
produces frontal fill-in light in locations with
by pressing the UP and DOWN
and DOWN buttons. The set-
repeatedly until the display is reset to its nor-
is not pressed, the display is automati-
buttons.
103